PRAGOPRIMER PROFI S2129
ANTICORROSIVE PRIMER
![](https://old.bal.cz/wp-content/uploads/2017/02/PRAGOPRIMER-PROFI-10kg-525x600.jpg)
Solvent-based anticorrosive primer is designed for steel and metal surfaces under solvent-based and oil topcoats, both interior and exterior. It is also possible to use it for coating of non-metal materials, porous surfaces, but it is necessary to penetrate before. The primer dries quickly and it is also designed for airless application in high build coats.
SURFACE PREPARATION
The surface has to be clean, dry and free of grease, rust and dust. Degrease by technical benzene P 6402, acetone P6401 or hot water with detergent. Salt residue rinse with water. Defective or poorly adhering impurities remove by sanding or scraping, thoroughly remove rust (metal brush, grindstone, rust remover). Rust remover rinse by water.
Porous materials impregnate for uniform absorbency of the surface.
Previously painted surfaces clean, degrease and remove all poorly adhering old coats to the solid surface when renovate. Verify compatibility between old paint and new one. Perform a test on the area 1 m<sup>2</sup>.
THINNER S 6005 for brush or roller, S 6006, S 6001 for spraying
RECOMMENDED APPLICATION
Mix properly before use. It shouldn´t be thinned, it is ready to use.
Steel: Apply 1 coat of primer PRAGOPRIMER PROFI S 2129 (drying can be forced till 80 °C). Apply 2-3 coats of INDUSTROL UNIVERZÁL S 2013 or INUSTROL UNIMAT S 2075.
Coverage
11-14 m²/kg in one coat
Application
- Brush
- Airless spray
- Roller