PRAGOPRIMER PRO PRŮMYSL S2000 P

Universal solvent-based anticorrosive primer is widely used as undercoat for steel and metal surfaces in interior and exterior, especially under air-drying solvent-based topcoats. It dries very quickly. It is also possible to use it for coating of non-metal materials, porous surfaces, but it is necessary to penetrate before.

SURFACE PREPARATION

The surface has to be clean, dry and free of grease, rust and dust. Degrease by technical benzene P 6402, acetone P 6401 or hot water with detergent. Salt residue rinse with water. Defective or poorly adhering impurities remove by sanding or scraping, thoroughly remove rust (metal brush, grindstone, rust remover). Rust remover rinse by water.
Porous materials impregnate for uniform absorbency of the surface.
Previously painted surfaces clean, degrease and remove all poorly adhering old coats to the solid surface when renovate. Verify compatibility between the old paint and new one. Perform a test on the area 1 m².

THINNER S 6001 for spraying, S6006 for brush or roller

RECOMMENDED APPLICATION

Mix properly before use, thin as needed.
Metal: Apply 1 coat of PRAGOPRIMER S 2000P, drying 24 hours (can be forced till 80 °C). Optimal film thickness is 25-30 μm. Cement, if necessary (i.e. BKP Rapid TOS). Sand it with a sandpaper no. 180-220 while wet. Apply 1 coat of PRAGOPRIMER S 2000P. Sand it with a sandpaper no. 280 after drying. Apply 1-2 coats of gloss enamel INDUSTROL UNIVERSAL S 2013, INDUSTROL PLUS S 2071 or matt INDUSTROL UNIMAT S 2075.
Porous material: Apply 1 coat of penetration LAZUROL CLASSIC S 1023 or LAZUROL FUNGICIDAL IMPREGNATION S 1033, drying time 24 hours. Apply 1 coat of PRAGOPRIMER S 2000P, drying time 24 hours. Cement, if necessary, see above. Apply 1-2 coats of gloss enamel INDUSTROL UNIVERSAL S 2013, INDUSTROL PLUS S 2071 or matt INDUSTROL UNIMAT S 2075.

Coverage

12-15 m²/l in one coat