EPOLEX BARVA NA VANY S2321 O

The solvent-based epoxy enamel uses for surface renovation of enamelled baths, shower trays and enclosures. Not for acrylic surfaces and exterior use.

SURFACE PREPARATION

The bath cleans thoroughly by cleanser to be free of grease, limescale and sediments. The surface smoothes by sandpaper no. 280-320 while wet for better adhesion. Rinse by water and let dry. Damaged spots, cracking enamel seal by epoxy putty for metal. Smooth by sandpaper no. 320-360 while wet after drying. The surface rinses by cleanser. Remove outlet and overflow, smooth and clean places below them. Avoid dripping of water. The surface has to be matt, clean and dry. Apply tape around bath. Minimum temperature of the surface is 15 °C. A draught could bring dust and cause defects on the surface.

THINNER S 6300
HARDENER S 7300

RECOMMENDED APPLICATION

Mix properly before use, add hardener in weight ratio S2321O: S7300 = 100: 33, mix together and let it defoam 15 minutes. Paint in a cross thin coat. Second coat applies after 24 hours. Contain of the can is for 2 coats of the bath.

Coverage

11-15 m²/1kg in one coat