EPOLEX ZÁKLAD PROFI S2300
TWO-PACK ANTICORROSIVE EPOXY PRIMER
![](https://old.bal.cz/wp-content/uploads/2017/10/s2300_epolex_zakladprofi.png)
- Anticorrosive primer
- Excellent adhesivity on all metals
- Thixotropic
The solvent-based anticorrosive primer uses on metal providing excellent paint adhesion and corrosion protection. The content mix with hardener S 7300 before use. It doesn´t run in thick build coats.
SURFACE PREPARATION
The surface has to be clean, dry and free of grease, rust and dust. Degrease by technical benzene P 6402, acetone P 6401 or hot water with detergent. Salt residue rinse with water. Defective or poorly adhering impurities remove by smoothing or scraping, thoroughly remove rust (metal brush, grindstone, rust remover). Rust remover rinse by water.
Previously painted surfaces clean, degrease and remove all poorly adhering old coats to the solid surface. Verify compatibility between old paint and new one. Perform a test on the area 1 m<sup>2</sup>.
THINNER S 6300
HARDENER S 7300
RECOMMENDED APPLICATION
Mix properly before use, add hardener in weight ratio S 2300: S 7300 = 100 : 17, mix together and thin as needed.
Metal: Apply 1 coat of EPOLEX PRIMER PROFI S 2300, next coat after drying at 20 °C for 24 hours (can be forced at 60-100 °C for 60-30 minutes).
Interior: Apply 1-2 coats of EPOLEX EMAIL PROFI S 2321.
Exterior: Apply 1-2 coats of TELPUR T 300.
Coverage
9-12 m²/kg in one coat
Application
- Brush
- Airless spray
- Roller