HOSTAGRUND 2v1 ZINEX S2820

The solvent-based acrylic single coat uses for painting on steel, light metal, galvanized steel in exterior and interior. It can be used under acrylic, polyurethane and epoxy topcoats. The coat has proper adhesion to steel, copper, aluminium and galvanized surfaces including fresh one. It dries quickly and the coat is resistant to weather conditions. The paint is slightly thixotropic, it doesn´t run from vertical surfaces.

SURFACE PREPARATION

The surface has to be clean, dry and free of grease, rust and dust. Degrease by technical benzene P 6402, acetone P 6401 or hot water with detergent. Salt residue rinse with water. Defective or poorly adhering impurities remove by smooth or scraping, thoroughly remove rust (metal brush, grindstone, rust remover). Rust remover rinse by water.
Previously painted surfaces clean, degrease and remove all poorly adhering old coats to the solid surface when renovate. Verify compatibility between old paint and new one. Perform a test on the area 1 m².

THINNER S 6005

RECOMMENDED APPLICATION

Mix properly before use, thin as needed.
Total dry film has to be 80 µm. Drying time of second coat would be slower.
Treat difficult places (corners, edges, welds, surface defects), when spraying at first. Paint these places by brush, then spray the whole area including treated places. Second coat applies after 24 hours, in case of spraying “wet to wet” after 15-30 minutes.

Coverage

10-12 m²/l in one coat